DIY: How To Make Wire Bangle by Lan Anh

Wire Bangle is now published as part of DIY Jewelry Making #60. This tutorial is written by one of our contributors – Lan Anh.  This tutorial will guide you on how to make a wire-wrapped bangle bracelet. With wire wrapping techniques you’ll make your own necklace or bracelet. How awesome is that! For step by step instruction, do login to our member area to follow this project. If you are not a member yet, just subscribe from the link here.


 
 
 
 

Materials needed:
18 gauge: 17cm
24 gauge: 2 x 60cm
stone diameter 6mm

 

 Below is a sneak preview of what you will see from the step by step guide available in our member area.

 

Step 1:
With your 18ga wire, make a loop at one end using your round nose pliers.

 

 

Step 2:
Fold the 2 pc 24ga wire in half and wrap just below the loop.

 

 

Step 3:
Slide a bead.

 

 

Step 4:
Wrap 1 set of 24ga wire once just below the bead going towards you. Do the same for the other set of 24ga wire, but this time in opposite direction and then repeat wrapping the wires 1 more time.

 

 

Step 5:
Repeat Step 3 & 4 until you reach your desired length.

 

 

Now, only $5.80/month, you can have INSTANT UNLIMITED ACCESS TO DIY JEWELRY MAKING MAGAZINES WITH OVER 500 jewelry tutorials!

Now, only $5.80/month, you can have INSTANT UNLIMITED ACCESS TO DIY JEWELRY MAKING MAGAZINES WITH OVER 500 jewelry tutorials!

Click on the buttons below to subscribe!